| Server IP : 104.21.38.3 / Your IP : 162.158.163.173 Web Server : Apache System : Linux krdc-ubuntu-s-2vcpu-4gb-amd-blr1-01.localdomain 5.15.0-142-generic #152-Ubuntu SMP Mon May 19 10:54:31 UTC 2025 x86_64 User : www ( 1000) PHP Version : 7.4.33 Disable Function : passthru,exec,system,putenv,chroot,chgrp,chown,shell_exec,popen,proc_open,pcntl_exec,ini_alter,ini_restore,dl,openlog,syslog,readlink,symlink,popepassthru,pcntl_alarm,pcntl_fork,pcntl_waitpid,pcntl_wait,pcntl_wifexited,pcntl_wifstopped,pcntl_wifsignaled,pcntl_wifcontinued,pcntl_wexitstatus,pcntl_wtermsig,pcntl_wstopsig,pcntl_signal,pcntl_signal_dispatch,pcntl_get_last_error,pcntl_strerror,pcntl_sigprocmask,pcntl_sigwaitinfo,pcntl_sigtimedwait,pcntl_exec,pcntl_getpriority,pcntl_setpriority,imap_open,apache_setenv MySQL : OFF | cURL : ON | WGET : ON | Perl : ON | Python : OFF | Sudo : ON | Pkexec : ON Directory : /usr/src/linux-headers-5.15.0-142/include/linux/pinctrl/ |
Upload File : |
/* SPDX-License-Identifier: GPL-2.0 */ /* * Standard pin control state definitions */ #ifndef __LINUX_PINCTRL_PINCTRL_STATE_H #define __LINUX_PINCTRL_PINCTRL_STATE_H /** * @PINCTRL_STATE_DEFAULT: the state the pinctrl handle shall be put * into as default, usually this means the pins are up and ready to * be used by the device driver. This state is commonly used by * hogs to configure muxing and pins at boot, and also as a state * to go into when returning from sleep and idle in * .pm_runtime_resume() or ordinary .resume() for example. * @PINCTRL_STATE_INIT: normally the pinctrl will be set to "default" * before the driver's probe() function is called. There are some * drivers where that is not appropriate becausing doing so would * glitch the pins. In those cases you can add an "init" pinctrl * which is the state of the pins before drive probe. After probe * if the pins are still in "init" state they'll be moved to * "default". * @PINCTRL_STATE_IDLE: the state the pinctrl handle shall be put into * when the pins are idle. This is a state where the system is relaxed * but not fully sleeping - some power may be on but clocks gated for * example. Could typically be set from a pm_runtime_suspend() or * pm_runtime_idle() operation. * @PINCTRL_STATE_SLEEP: the state the pinctrl handle shall be put into * when the pins are sleeping. This is a state where the system is in * its lowest sleep state. Could typically be set from an * ordinary .suspend() function. */ #define PINCTRL_STATE_DEFAULT "default" #define PINCTRL_STATE_INIT "init" #define PINCTRL_STATE_IDLE "idle" #define PINCTRL_STATE_SLEEP "sleep" #endif /* __LINUX_PINCTRL_PINCTRL_STATE_H */